drying steam atmospheric pressure fire tube boiler
HOT
Capacity:1-20t/h
Rated thermal efficiency: 100-104%
Fixed working pressure: ≤1.6MPa
Applicable fuel:natural gas etc.
HOT
Capacity:0.7-14MW
Rated thermal efficiency:96-98%
Fixed working pressure:≤1.25MPa
Applicable fuel:Natural gas, light oil, etc.
HOT
Capacity:0.7-2.8Mw
Rated thermal efficiency: 97.2-106%
Fixed working pressure:0.1MPa
Applicable fuel:Natural gas, etc.
HOT
Capacity:2.8-7.0Mw
Rated thermal efficiency:≥105.5%
Fixed working pressure:-0.02MPa
Applicable fuel:Natural gas, etc.
HOT
Capacity:99Kw
Rated thermal efficiency:97.2-104.4%
Fixed working pressure:1.0MPa
Applicable fuel:Natural gas, etc.
HOT
Capacity:0.5-4.0 t/h
Rated thermal efficiency:98%
Fixed working pressure:≤1.25MPa
Applicable fuel:electric energy
At 60°F and atmospheric pressure, the solubility of oxygen in water is approximately 8 ppm. Equipment vulnerable to erosion includes turbine blades, low-pressure steam piping, and heat exchangers that are subjected to wet steam. The trays are placed in each drum of a water tube boiler, or on the top flues of a fire-tube unit. All Get Price
First: check the operating pressure of the boiler. At full operating temperature the system pressure should be under 30 psi. When the boiler is cold, the pressure should be around 12-18 psi. If the boiler pressure is abnormally high the problem is elsewhere - a bad water feeder or a tankless coil leaking into the boiler.Get Price
Fire damper means a closure that consists of a damper installed in an air distribution system or in a wall or floor assembly that is normally held in the open position and that is designed to close automatically in the event of a Venting Atmospheric and Low-Pressure Storage Tanks. 4.3.4.1.(1) Boiler, Pressure Vessel and Pressure Piping Get Price
A boiler or steam generator is a device used to create steam by applying heat energy to water.Although the definitions are somewhat flexible, it can be said that older steam generators were commonly termed boilers and worked at low to medium pressure (7–2,000 kPa or 1–290 psi) but, at pressures above this, it is more usual to speak of a steam generator.Get Price
Boiler safety is of utmost importance in view of the large amount of energy stored in the form of superheated water. The boiler water, which is heated above its atmospheric pressure boiling point, will flash-boil to a very large and destructive volume of steam should the boiler suffer structural failure precipitated by too low a water level.Get Price
Pressure at the bottom (kg/cm 2 g) 2.5 4.3. As a practice, while a vacuum condition is likely to occur due to malfunction during steam purge or emergency shutdown of reboilers (all condensable vapor service), etc, the vessel should be designed to withstand full vacuum.Get Price
A good precaution is to install two valves in series to protect the CO on of check valves. •a c o o m _> 8 boiler from .sludge backing up into boiler tubes. Use temperature readouts or gauges. . ' ' •*' * • sludge temperature o 'E 0 "*' Water temperature above 130 deg. F. (54 deg. C.) will cause sludge to bake on tube and cut down heat Get Price
- Direct steam-type humidifiers inject boiler-generated steam directly into the air stream. These systems normally operate above 70 degrees C (158 degrees F), and Legionella cannot survive at that temperature. - Atomizing humidifiers use mechanical devices or pneumatic air to create a water mist that evaporates into the air stream.Get Price
The steam line is insulated with 5.08 cm thickness of 85% magnesia. For an ambient temperature of 22C, what is the quality of the steam which arises at its destination if the mass flow rate is 0.125 kg steam per second? Properties of Steam: Pressure=2.05 MPa, Temperature=213.67 C. Enthalpy: hf=914.52 kJ/kg. hfg=1885.5 kJ/kg. hg=2800.00 kJ/kgGet Price
- Direct steam-type humidifiers inject boiler-generated steam directly into the air stream. These systems normally operate above 70 degrees C (158 degrees F), and Legionella cannot survive at that temperature. - Atomizing humidifiers use mechanical devices or pneumatic air to create a water mist that evaporates into the air stream.Get Price
Steam Production At normal atmospheric pressure, any further addition of heat to water at 100°C will not increase the temperature but will convert some of the water into steam In order to convert water into steam 2,257 kJ/kg (971Btu/lb) of additional heat must be added This cannot be detected as a rise in temperature and is called the LatentGet Price
Dec 01, 2016 · Sensors should be installed to activate an audible signal if the boiler or gas system temperature and/or pressure goes outside of set limits, or if a fire should occur in the digester equipment room. Signs warning of danger should be prominently displayed around the digester (Figure 55), and the system should be fenced in and locked to keep Get Price
Steam Production At normal atmospheric pressure, any further addition of heat to water at 100°C will not increase the temperature but will convert some of the water into steam In order to convert water into steam 2,257 kJ/kg (971Btu/lb) of additional heat must be added This cannot be detected as a rise in temperature and is called the LatentGet Price
Pressure at the bottom (kg/cm 2 g) 2.5 4.3. As a practice, while a vacuum condition is likely to occur due to malfunction during steam purge or emergency shutdown of reboilers (all condensable vapor service), etc, the vessel should be designed to withstand full vacuum.Get Price
Steam and hot water boilers, respectively, shall be provided with approved automatic limiting devices for shutting down the burner(s) to prevent boiler steam pressure or boiler water temperature from exceeding the maximum allowable working pressure or temperature. Safety limit controls shall not be used as operating controls.Get Price
4. Explosion or failure of structure affecting the safety or strength of a steam boiler or of an unfired pressure vessel; the loss of boiler water, the melting of a fusible plug and the bursting of a tube. SECOND SCHEDULE SERIOUS BODILY INJURY [Section 3] 1. Emasculation. 2. Permanent privation of the sight of either eye. 3.Get Price
First: check the operating pressure of the boiler. At full operating temperature the system pressure should be under 30 psi. When the boiler is cold, the pressure should be around 12-18 psi. If the boiler pressure is abnormally high the problem is elsewhere - a bad water feeder or a tankless coil leaking into the boiler.Get Price
The term boiler is applied to the single heat source that can supply either steam or hot water (a boiler is often called a heater). Boilers may be classified according to several kinds of characteristics. They are typically made from cast iron or steel. Their construction design may be sectional, portable, fire-tube, water-tube, or special.Get Price
At 60°F and atmospheric pressure, the solubility of oxygen in water is approximately 8 ppm. Equipment vulnerable to erosion includes turbine blades, low-pressure steam piping, and heat exchangers that are subjected to wet steam. The trays are placed in each drum of a water tube boiler, or on the top flues of a fire-tube unit. All Get Price
Containers used with systems embodied in paragraphs (d), (e), (g), and (h) of this section, except as provided in paragraphs (e)(3)(iii) and (g)(2)(i) of this section, shall be designed, constructed, and tested in accordance with the Rules for Construction of Unfired Pressure Vessels, section VIII, Division 1, American Society of Mechanical Engineers (ASME) Boiler and Pressure Vessel …Get Price
Boiler safety is of utmost importance in view of the large amount of energy stored in the form of superheated water. The boiler water, which is heated above its atmospheric pressure boiling point, will flash-boil to a very large and destructive volume of steam should the boiler suffer structural failure precipitated by too low a water level.Get Price
A boiler or steam generator is a device used to create steam by applying heat energy to water.Although the definitions are somewhat flexible, it can be said that older steam generators were commonly termed boilers and worked at low to medium pressure (7–2,000 kPa or 1–290 psi) but, at pressures above this, it is more usual to speak of a steam generator.Get Price
The steam line is insulated with 5.08 cm thickness of 85% magnesia. For an ambient temperature of 22C, what is the quality of the steam which arises at its destination if the mass flow rate is 0.125 kg steam per second? Properties of Steam: Pressure=2.05 MPa, Temperature=213.67 C. Enthalpy: hf=914.52 kJ/kg. hfg=1885.5 kJ/kg. hg=2800.00 kJ/kgGet Price
The term boiler is applied to the single heat source that can supply either steam or hot water (a boiler is often called a heater). Boilers may be classified according to several kinds of characteristics. They are typically made from cast iron or steel. Their construction design may be sectional, portable, fire-tube, water-tube, or special.Get Price
1.3.44 Oil fuel unit is the equipment used for the preparation of oil fuel for delivery to an oil-fired boiler, or equipment used for the preparation for delivery of heated oil to an internal combustion engine, and includes any oil pressure pumps, filters and heaters dealing with oil at a pressure more than 0.18 N/mm 2. Oil transfer pumps are Get Price
Feel free to reach out if you want to collaborate with us, or simply have a chat.
